STEPT ONE
With the clip side of the piece facing you, put both thumbs on each side of the clip and the index fingers at the front sides. Snap the clip open by applying pressure toward yourself with the index fingers. Similarly, close the clip by applying pressure away from yourself with the thumbs.
STEPT TWO
Separate the hair. Using a tail comb or your index fingers, part the hair horizontally from one side of the head to the other. Starting about an inch above the ears, part the hair around the back of the head just below the crown and to the other ear.
Clip up the hair above the part. Lift up all the hair above the part and clip it out of the way using duck bill clip(s).Pin up the hair that is below the part. Take the remaining hair and secure in large pin curls so that it lays as flat to the head as possible.
STEPT THREE
Placement of the first clip. Open all the clips on the piece. The top middle clip (1) should be attached first by placing it at the middle of the back of the head just below the part so that the top of the weft is even with the part when attached. Moving the clip downward, catch your hair in the clip and snap it shut.
Placement of the second and third clips. Attach the left top clip (2) next. Hold down the center clip with your right hand, and use your left hand to move the left edge of the weft as far as it will go around your head. Snap left clip shut. Holding the middle clip with your left hand, now attach the top right clip (3) in the same fashion. Check for gaps by running your fingers along the top weft to make sure it lies flat against your head. If you find a gap, open the clip and reposition.
Placement of the remaining clips. The bottom right clip (4) is next. Pull the hair out of the way and place this clip by stretching the piece down to the bottom edge of the nape and slipping the clip into your hair, making sure the clip securely catches the hair at the end of the nape. Repeat on the left bottom clip (5). Next attach the right side clip (6) behind your ears. Finally, attach the left side clip (7).
STEPT FOUR
Finishing the look. Release all the hair that was clipped out of the way with the duck-bill clip(s) and blend in with Hairdo™ Clip-in Extensions.
Removing the wefts. To remove the piece, snap open all the clips and gently lift up and away from your hair.
Caring for your new hair product is easy, and you should treat your new product as an investment that you want to keep looking new and fresh for as long as possible. The correct care and maintenance will allow you to continue using the product with the best results for the longest amount of time. So, use the following instructions as a gauge for determining how and when you should wash and care for your products. And, know that you can always call 86-53285685100 EMEDA HAIR and speak to a licensed cosmetologist for answers to all your questions.